The trapezoidal corrugated TRD-91.5 is a product made in plant by a stationary roladora from steel roll Ternium Zintro, Ternium Zintro Alum o Ternium Pintro, whose geometry satisfies the dimensions set by the SDI (Steel Deck Institute) for the profile called "Wide Rib" or Type B, and Standard ANSI / SDI-RD1.0. This product is picklable (anidable) and therefore traslapable.
This product is intended exclusively for use as a substrate resistant (deck) in building "composite decking". It should not be used as product fixing corrugated exposed as waterproofing unless a complete overlap ridge. It can also be used as architectural facade.
* Calibre 18 only manufactured under technical consultation
1. (¹) Maximum separation between supports recommended by the SDI "Roof Deck de 1-1/2".
2. The wind suction loads NO are increased in 33% accidental load being.
3. The values of live load and wind suction were limited 300 kg/m2.
4. Shaded values are limited by a maximum deflection of L / 240.
5. The properties and capacity were calculated for steel Fy = 2600 kg/Cm2,(Fb= 1560 Kg/Cm2)
6. Projects must be calculated by a responsible engineer to meet the same codes, standards and procedures accepted by the construction industry. 